[1] D. N. Borza, “Mechanical vibration measurement by high-resolution time averaged digital holography,” Measurement Science and Technology, 2005, 16(9): 1853–1864.
[2] H. Tazawa, T. Kanie, and M. Katayama, “Fiber-optic coupler based refractive index sensor and its application to bio-sensing,” Applied Physics Letters, 2007, 91(11): 113901–133905.
[3] F. T. S. Yu and S. Yin, Fiber optic sensors. New York: Marcel Dekker Inc., 2002.
[4] E. Udd and W. B. S. Jr, Fiber optic sensor: an introduction for engineers and scientists. New York: John Wiley & Sons Inc., 1991.
[5] H. C. Seat and S. Pullteap, “An extrinsic fiber fabry-perot interferometer for dynamic displacement measurement,” in IEEE International Conference on Mechatronics and Automation (ICMA), Harbin, pp. 3025–3030, 2007.
[6] K. Kesavan, K. Ravisankar, S. Parivallal, P. Sreeshylam, and S. Sridhar, “Experimental studies on fiber optic sensors embedded in concrete,” Measurement, 2010, 43(2): 157–163.
[7] B. Regez, M. Sayeh, A. Mahajan, and F. Figueroa, “A novel fiber optics based method to measure very low strains in large scale infrastructures,” Measurement, 2009, 42(2): 183–188.
[8] S. Pullteap, “Development of an optical fiber based interferometer for small vibration measurement,” in IEEE International Conference on Optical Communication and Network (ICOCN), Chonburi, pp. 107–110, 2012.
[9] P. Antunes, A. M. Rocha, H. Lima, H. Varum, and P. S. Andre, “Thin bonding wires temperature measurement using optical fiber sensors,” Measurement, 2011, 44(3): 554–558.
[10] H. C. Seat, S. Pullteap, and T. Bosch, “An extrinsic fibre optic interferometer with possible signal fading compensation for vibrometric applications,” in Proceedings of the IEEE Instrumentation and Measurement Technology Conference, Ottawa, pp. 2236–2241, 2005.
[11] X. Zhou and Q. Yu, “Wide-range displacement sensor based on fiber-optic fabry-perrot interferometer for subnanometer measurement,” IEEE Sensors Journal, 2011, 11(7): 1602–1606.
[12] A. Khiat. F. Lamarque, C. Prelle, P. Pouille, M. L. Schadel, and S. Buttgenbach, “Two-dimension fiber optic sensor for high-resolution and long-range linear menaurements,” Sensors and Actuators A: Physical, 2010, 158(1): 43–50.
[13] R. P. Tatam, “Applied optics to engineering photonics: a retrospective,” Photonic sensors, 2011, 1(4): 295–322.
[14] B. Chen, J. Luo, and D. Li, “Code counting of optical fringes: methodology and realization,” Applied Optics, 2005, 44(2): 217–223.
[15] T. K. Gangopadhyay, “Non-contact vibration measurement based on an extrinsic Fabry-Perot interferometer implemented using arrays of single-mode fibres,” Measurement Science and Technology, 2004, 15(5): 911–917.
[16] S. Pullteap, H. C. Seat, and T. Bosch, “Modified fringe-counting technique applied to a dual-cavity fiber Fabry-Pérot vibrometer,” Optical Engineering, 2007, 46(11): 115603-1–115603-8.
[17] G. Hernandez, Fabry-perot interferometers. Cambridge: Cambridge University Press, 1986.
[18] M. Norgia and C. Svelto, “Novel measurement method for signal recovery in optical vibrometer,” IEEE Transactions on Instrumentation and Measurement, 2008, 57(8): 1703–1707.
[19] S. Topcu, L. Chassagne, D. Haddad, and Y. Alayli, “Heterodyne interferometric technique for displacement control at the nanometric scale,” Review of Scientific Instruments, 2003, 74(11): 4876–4880.
[20] Y. Zhu, J. D. Zuegel, J. R. Marciante, and H. Wu, “Distributed waveform generator: a new circuit technique for ultra-wideband pulse generation, shaping and modulation,” IEEE Journal of Solid-State Circuits, 2009, 44(3): 808–823.
[21] K. J. Gasvik, Optical Metrology. London: Wiley & Sons., 2002.
[22] K. J. Gasvik, K. G. Robbersmyr, and T. Vadseth, “Fringe location by means of a zero-crossing algorithm,” in Proc. SPIE, vol. 1163, pp. 64–70, 1989.
