[1] Liu Hongxi, Leng Ning, Zhang Xiaowei, et al. Microstructure and wear behavior of WC/CO50 composite coating on 40Cr cutting tool surface prepared by laser cladding [J]. Infrared and Laser Engineering, 2015, 44(1): 178-183. (in Chinese)

[2] Zeng Chao, Tian Wei, Liao Wenhe, et al. Study of laser cladding thermal damage: a quantified microhardness method [J]. Surf Coat Tech, 2013, 236(24): 309-314.

[3] Li Jianzhong, Li Xiangfeng, Zuo Dunwen, et al. Influence of defocusing amount on the process of Al/Ti cladding above 7050 aluminum alloy based on numerical simulation study [J]. Infrared and Laser Engineering, 2014, 44(4): 1126-1133. (in Chinese)

[4] Zhou Chaoyu, Lin Chengxin, Xu Peng, et al. In situ synthesis of Fe-Mn-Si memory alloy on the surface of stainless steel by laser cladding [J]. Rare Metal Mat Eng, 2014, 43(12): 3042-3046. (in Chinese)

[5] Zhang Ping, Ma Lin, Zhao Junjun, et al. The heat source model of the numerical simulation in the laser cladding[J]. China Surface Engineering, 2006, 19(5): 161-164. (in Chinese)

[6] Suárez A, Amado J M, Tobar M J, et al. Study of residual stresses generated inside laser cladded plates using FEM and diffraction of synchrotron radiation[J]. Surf Coat Tech, 2010, 204(12): 1983-1988.

[7] Yang Xianqun. Predicting the quality of clad in laser cladding by powder and numerical simulation of cladding process [D]. Harbin: Harbin Institute of Technology, 2008. (in Chinese)

[8] Oliveira U D, Ocelík V, Hosson J T. Residual stress analysis in co-based laser clad layers by laboratory X-rays and synchrotron diffraction techniques[J]. Surf Coat Tech, 2006, 201(3): 533-542.

[9] Bendeich P, Alam N, Brandt M, et al. Residual stress measurements in laser clad repaired low pressure turbine blades for the power industry[J]. Mater Sci Eng A, 2006, 437(1): 70-74.

[10] Gu Jianqiang, Luo Fang, Yao Jianhua. Numerical simulation of residual stress during laser cladding[J]. Laser & Optoelectronics Progress, 2010, 47(10): 81-86. (in Chinese)