Yumi Kaneyasu, Keiji Nagai, Marilou Cadatal-Raduban, Daniil Golovin, Satoshi Shokita, Akifumi Yogo, Takahisa Jitsuno, Takayoshi Norimatsu, Kohei Yamanoi. Fabrication of disk-shaped, deuterated resorcinol/formaldehyde foam target for laser–plasma experiments[J]. High Power Laser Science and Engineering, 2021, 9(2): 02000e31
- High Power Laser Science and Engineering
- Vol. 9, Issue 2, 02000e31 (2021)
Fig. 1. Schematic diagram of (a) the chemical reaction and (b) procedures.
Fig. 2. Change in viscosity during polymerization for each sample.
Fig. 3. SEM images of (a) disk-shaped d-RF and (b) bulk d- RF fabricated at R/C = 50 and 300 min heating time, (c) n-RF fabricated at R/C = 200 and 300 min heating time, and (d) n-RF fabricated at R/C = 200 and 350 min heating time.
Fig. 4. Photograph of the disk-shaped d-RF foam targets inside the holders.
|
Table 1. Information about samples and each time to reach 100 mPa s by polymerization.
Set citation alerts for the article
Please enter your email address
© Copyright 2018-2021 | Chinese Laser Press. All Rights Reserved 沪ICP备15018463号-20