[1] Yao Hanmin, Hu Song, Xing Tingwen. Optical Projection Lithography Micromachining Technology[M]. Beijing: Beijing University of Technology Press, 2006. 162-165.

[2] Liu Ming, Chen Baoqin, Xie Changqing, et al.. Application of micro/nanofabrication on micro/nano electrical devices[J]. Physics, 2006, 35(1): 47-50.

[3] George M Whitesides, Emanuele Ostuni, Shuichi Takayama, et al.. Soft lithography in biology and biochemistry[J]. Annu Rev Biomed Eng, 2001, 3: 335-373.

[4] Scharnweber T, Truckenmüller R, Schneider AM T, et al.. Rapid prototyping of microstructures in polydimethylsiloxane (PDMS) by direct UV-lithography[J]. Lab Chip, 2011, 11(7): 1368-1371.

[5] Weiqiang Chen, Raymond H W Lam, Jianping Fu. Photolithographic surface micromachining of polydimethylsiloxane (PDMS)[J]. Lab Chip, 2012, 12(2): 391-395.

[6] Y Zhang, N Gao, C Xie. Using circular Dammann gratings to produce impulse optic vortex rings[J]. Appl Phys Lett, 2012, 100(4): 041107.

[7] Yao P, Schneider G, Prather D, et al.. Fabrication of three-dimensional photonic crystals with multilayer photolithography[C]. SPIE, 2005, 5720: 27-35.

[8] D J Chen, F P Chiang. Computer-aided speckle interferometry using spectral amplitude fringes[J]. Appl Opt, 1993, 32(2): 225-236.

[9] P J Caber. Interferometric profiler for rough surfaces[J]. Appl Opt, 1993, 32(19): 3438-3441.

[10] J C Wyant. Computerized interferometric surface measurements[J]. Appl Opt, 2013, 52(1): 1-8.

[11] J C Wyant, V P Bennett. Using computer generated holograms to test aspheric wavefronts[J]. Appl Opt, 1972, 11(12): 2833-2839.

[12] Zeng Xuefeng, Yan Feng, Xue Donglin, et al.. Distortion correction in testing of off-axis asphere with computer-generated hologram[J]. Chinese J Lasers, 2013, 40(11): 1109003.

[13] Gao Songtao, Sui Yongxin, Yang Huaijiang, et al.. High precise testing of asphere with computer-generated hologram and error evaluation[J]. Acta Optica Sinica, 2013, 33(6): 0612003.

[14] D C F, H I Smith. A new interferometric alignment technique[J]. Appl Phys Lett, 1977, 31(7): 426-428.

[15] Junji Itoh, Toshihiko Kanayama, Nobufumi Atoda, et al.. An alignment system for synchrotron radiation x-ray lithography[J]. J Vac Sci Technol B, 1988, 16(6): 409-412.

[16] G Bouwhuis, S Wittekoek. Automatic alignment system for optical projection printing[J]. Electron Devices, IEEE Transactions, 1979, 26(4): 723-728.

[17] G Pugh, M Giorgi. Evaluation of ASML ATHENA alignment system on intel front-end processes[C]. SPIE, 2002, 4689: 286-294.

[18] Li Guang, Zhu Jiangping, Chen Mingyong, et al.. Novel coaxial focusing method based on interference[J]. Chinese J Lasers, 2013, 40(12): 1208005.

[19] Moon, Euclid E, Chen Lynn, Everett Patrick N, et al.. Interferometric-spatial-phase imaging for six-axis mask control[J]. J Vac Sci Technol B, 2003, 21(6): 3112-3115.

[20] Zhou Shaolin, Tang Xiaoping, Hu Song, et al.. Analysis of moire pattern of dual gratings alignment in nanometer lithography[J]. Opto-electronic Engineering, 2008, (3): 13-17.

[21] Ma Ping, Zhou Shaolin, Hu Song, et al.. The analysis of moiré fringes and application on the alignment of lithography[J]. Opto-electronic Engineering, 2010, 37(7): 102-106.

[22] Zhou Shaolin, Yang Yong, Chen Fuwang, et al.. Dual-grating-based nanometer measurement[J]. Acta Optica Sinica, 2009, 29(3): 702-706.