[1] Zhang Anfeng, Li Dichen, Lu Bingheng. Research process in laser direct metal rapid prototyping technology［J］. Ordnance Material Science and Engineering, 2007, 30(5): 68～72

[2] Zhong Minlin, Ning Guoqing, Liu Wenjin. Research and development on laser direct manufacturing metallic component［J］. Laser Technology, 2002, 26(5): 388～391

[3] Zhang Dongyun, Wang Ruize, Zhao Jianzhe et al.. Lastest advance of laser direct manufacturing of metallic parts［J］. Chinese J. Lasers, 2010, 37(1): 18～25

[4] Edson Costa Santos, Masanari Shiomi, Kozo Osakada et al.. Rapid manufacturing of metal components by laser forming［J］. International Journal of Machine Tools & Manufacture, 2006, 46(12-13): 1459～1468

[5] X. Wu, J. Mei. Near net shape manufacturing of components using direct laser fabrication technology［J］. J. Mater. Process. Technol., 2003, 135(2-3): 266～270

[6] Zhong Minlin, Yang Lin, Liu Wenjin et al.. Laser direct manufacturing W/Ni telescope collimation component［J］. Chinese J. Lasers, 2004, 31(4): 482～486

[7] Vamsi Krishna Balla, Partha P. Bandyopadhyay, Susmita Bose et al.. Compositionally graded yttria-stabilized zirconia coating on stainless steel using laser engineered net shaping (LENSTM)［J］. Scripta Materialia, 2007, 57(9): 861～864

[8] Huang Weidong, Lin Xin, Chen Jing et al.. Laser Solid Forming［M］. Xi′an: Northwestern Polytechnical University Press, 2007. 10～20

[9] Pi Gang, Zhang Anfeng , Zhu Gangxian et al.. Self-healing-effect in laser direct metal manufacturing［J］. Journal of Xi′an Jiaotong University, 2010, 44(11):77～81

[10] Li Peng, Ji Shengqin, Zeng Xiaoyan et al.. Direct laser fabrication of thin-walled metal parts under open-loop control［J］. International Journal of Machine Tools & Manufacture, 2007, 47(6): 996～1002

[11] Hua Tan, Ijng Chen, Fengying Zhang et al.. Process analysis for laser solid forming of thin-wall structure［J］. International Journal of Machine Tools & Manufacture, 2010, 50(1): 1～8

[12] Zhu Gangxian, Zhang Anfeng, Li Dichen. Optimization of process parameters for laser cladding based on NdYAG［J］. Applied Laser, 2009, 29(5): 388～392

[13] Yu Jun, Chen Jing, Tan Hua et al.. Effect of process parameters in the laser rapid forming on deposition layer［J］. Chinese J. Lasers, 2007, 34(7): 1014～1018

[14] Yang Xichen, Lei Jianbo, Liu Yunwu et al.. Experimental measurement of metal powder stream concentration field in laser manufacturing［J］. Chinese J. Lasers, 2006, 33(7): 993～997

[15] Lu Qiaopan, Zhang Anfeng, Li Dichen et al.. Numerical simulation and experimental research on gas-carrier coaxial powder nozzle［J］. Chinese J. Lasers, 2010, 37(12): 3162～3167

[16] Pi Gang. Research on the Forming Process of 316L Stainless Steel Parts Fabricated by Laser Direct Metal Forming［D］. Xi′an: Xi′an Jiaotong University, 2010