High-strength alumina (Al₂O₃) was utilized as a reinforcing phase to improve the strength of hydroxyapatite (HA), a bioactive material, but the HA-Al₂O₃ ceramics prepared by traditional hydrothermal method could not achieve the precise control of pore size and porosity, whereas the light curing additive manufacturing technology could achieve the high precision molding of HA-Al₂O₃ ceramics through the high-performance photocurable slurry. The state of HA-Al₂O₃ slurry is adjusted by the addition of dispersant, photoinitiator, and photoabsorbent to alleviate the severe scattering effect caused by the refractive index mismatch between HA powder, Al₂O₃ powder, and photosensitive resin. In this study, the effects of the type and content of photoinitiator and dispersant on the slurry were explored. The rheological and curing properties of the slurry are first improved and then weakened with the addition of both, and the optimal dosages of photoinitiator and dispersant are 0.5% and 4% (mass fraction), respectively. The effects of two light absorbers, graphite and methyl yellow, on improving the printing accuracy were compared. Although graphite improves the printing accuracy and rheology of the slurry, it reduces the printing quality, so the dosage of 5.0×10^-5 methyl yellow is determined, and finally HA-Al₂O₃ slurries suitable for high precision printing are obtained.