Contents
2017
Volume: 7 Issue 3
10 Article(s)
Export citation format
Regular
Distributed Acoustic Sensing With Michelson Interferometer Demodulation
Xiaohui LIU, Chen WANG, Ying SHANG, Chang WANG, Wenan ZHAO, Gangding PENG, and Hongzhong WANG
The distributed acoustic sensing (DAS) has been extensively studied and widely used. A distributed acoustic sensing system based on the unbalanced Michelson interferometer with phase generated carrier (PGC) demodulation was designed and tested. The system could directly obtain the phase, amplitude, frequency response, The distributed acoustic sensing (DAS) has been extensively studied and widely used. A distributed acoustic sensing system based on the unbalanced Michelson interferometer with phase generated carrier (PGC) demodulation was designed and tested. The system could directly obtain the phase, amplitude, frequency response, and location information of sound wave at the same time and measurement at all points along the sensing fiber simultaneously. Experiments showed that the system successfully measured the acoustic signals with a phase-pressure sensitivity about –148 dB (re rad/μPa) and frequency response ripple less than 1.5 dB. The further field experiment showed that the system could measure signals at all points along the sensing fiber simultaneously..
Photonic Sensors
- Publication Date: Jan. 01, 1900
- Vol. 7, Issue 3, 193 (2017)
Potential of SPR Sensors Based on Multilayer Interfaces With Gold and LHM for Biosensing Applications
Abdellatif CHERIFI, and Benamar BOUHAFS
Recently, the subject on “plasmonics’’ has received significant attention in designing surface plasmon resonance (SPR) sensors. In order to achieve extremely high-sensitivity sensing, multilayered configurations based on a variety of active materials and dielectrics have been exploited. In this work, a novel SPR sensorRecently, the subject on “plasmonics’’ has received significant attention in designing surface plasmon resonance (SPR) sensors. In order to achieve extremely high-sensitivity sensing, multilayered configurations based on a variety of active materials and dielectrics have been exploited. In this work, a novel SPR sensor is proposed and investigated theoretically. The structure, analyzed in attenuated total reflection (ATR), consists of multilayer interfaces between gold and a metamaterial (LHM) separated by an analyte layer as a sensing medium. By interchanging between gold and LHM, under the effect of the refractive index (RI) of analyte set to be in the range of 1.00 to 1.99, the sharp peak reflectivity at the SPR angle takes two opposite behaviors predicted from the transfer matrix method. At the threshold value of 1.568 of the refractive index of analyte and when the LHM is the outer medium, the layered structure exhibits a giant sharp peak located at 43° of intensity up to 105 due to the Goos-Hànchen effect. With respect to the refractive index (RI) change and thickness of analyte, the characteristics (intensity, resonance condition, and quality factor) of the SPR mode, which make the proposed device have the potential for biosensing applications, have been analytically modelized..
Photonic Sensors
- Publication Date: Jan. 01, 1900
- Vol. 7, Issue 3, 199 (2017)
Low-Frequency Vibration Measurement by a Dual-Frequency DBR Fiber Laser
Bing ZHANG, Linghao CHENG, Yizhi LIANG, Long JIN, Tuan GUO, and Bai-Ou GUAN
A dual-frequency distributed Bragg reflector (DBR) fiber laser based sensor is demonstrated for low-frequency vibration measurement through the Doppler effect. The response of the proposed sensor is quite linear and is much higher than that of a conventional accelerometer. The proposed sensor can work down to 1 Hz withA dual-frequency distributed Bragg reflector (DBR) fiber laser based sensor is demonstrated for low-frequency vibration measurement through the Doppler effect. The response of the proposed sensor is quite linear and is much higher than that of a conventional accelerometer. The proposed sensor can work down to 1 Hz with high sensitivity. Therefore, the proposed sensor is very efficient in low-frequency vibration measurement..
Photonic Sensors
- Publication Date: Jan. 01, 1900
- Vol. 7, Issue 3, 206 (2017)
An Arc Tangent Function Demodulation Method of Fiber-Optic Fabry-Perot High-Temperature Pressure Sensor
Qianyu REN, Junhong LI, Yingping HONG, Pinggang JIA, and Jijun XIONG
A new demodulation algorithm of the fiber-optic Fabry-Perot cavity length based on the phase generated carrier (PGC) is proposed in this paper, which can be applied in the high-temperature pressure sensor. This new algorithm based on arc tangent function outputs two orthogonal signals by utilizing an optical system, whA new demodulation algorithm of the fiber-optic Fabry-Perot cavity length based on the phase generated carrier (PGC) is proposed in this paper, which can be applied in the high-temperature pressure sensor. This new algorithm based on arc tangent function outputs two orthogonal signals by utilizing an optical system, which is designed based on the field-programmable gate array (FPGA) to overcome the range limit of the original PGC arc tangent function demodulation algorithm. The simulation and analysis are also carried on. According to the analysis of demodulation speed and precision, the simulation of different numbers of sampling points, and measurement results of the pressure sensor, the arc tangent function demodulation method has good demodulation results: 1 MHz processing speed of single data and less than 1% error showing practical feasibility in the fiber-optic Fabry-Perot cavity length demodulation of the Fabry-Perot high-temperature pressure sensor..
Photonic Sensors
- Publication Date: Jan. 01, 1900
- Vol. 7, Issue 3, 234 (2017)
Distributed Fiber Optic Interferometric Geophone System Based on Draw Tower Gratings
Ruquan XU, Huiyong GUO, and Lei LIANG
A distributed fiber optic interferometric geophone array based on draw tower grating (DTG) array is proposed. The DTG geophone array is made by the DTG array fabricated based on a near-contact exposure through a phase mask during the fiber drawing process. A distributed sensing system with 96 identical DTGs in an equalA distributed fiber optic interferometric geophone array based on draw tower grating (DTG) array is proposed. The DTG geophone array is made by the DTG array fabricated based on a near-contact exposure through a phase mask during the fiber drawing process. A distributed sensing system with 96 identical DTGs in an equal separation of 20 m and an unbalanced Michelson interferometer for vibration measurement has been experimentally validated compared with a moving-coil geophone. The experimental results indicate that the sensing system can linearly demodulate the phase shift. Compared with the moving coil geophone, the fiber optic sensing system based on DTG has higher signal-to-noise ratio at low frequency..
Photonic Sensors
- Publication Date: Jan. 01, 1900
- Vol. 7, Issue 3, 246 (2017)
Development of High Sensitivity Eight-Element Multiplexed Fiber Laser Acoustic Pressure Hydrophone Array and Interrogation System
Ming LI, Zhihui SUN, Xiaolei ZHANG, Shujuan LI, Zhiqiang SONG, Meng WANG, Jian GUO, Jiasheng NI, Chang WANG, Gangding PENG, and Xiangang XU
Fiber laser hydrophones have got widespread concerns due to the unique advantages and broad application prospects. In this paper, the research results of the eight-element multiplexed fiber laser acoustic pressure array and the interrogation system are introduced, containing low-noise distributed feedback fiber laser (Fiber laser hydrophones have got widespread concerns due to the unique advantages and broad application prospects. In this paper, the research results of the eight-element multiplexed fiber laser acoustic pressure array and the interrogation system are introduced, containing low-noise distributed feedback fiber laser (DFB-FL) fabrication, sensitivity enhancement packaging, and interferometric signal demodulation. The frequency response range of the system is 10 Hz-10 kHz, the laser frequency acoustic pressure sensitivity reaches 115 dB re Hz/Pa, and the equivalent noise acoustic pressure is less than 60μPa Hz1/2. The dynamic range of the system is greater than 120 dB..
Photonic Sensors
- Publication Date: Jan. 01, 1900
- Vol. 7, Issue 3, 253 (2017)
Research on Multi-Component Gas Optical Detection System Based on Conjugated Interferometer
Xin GUI, Yuheng TONG, Honghai WANG, Haihu YU, and Zhengying LI
An optical multi-component gas detection system based on the conjugated interferometer (CI) is proposed and experimentally demonstrated. It can realize the concentration detection of mixture gas in the environment. The CI can transform the absorption spectrum of the target gases to a conjugated emission spectrum, when An optical multi-component gas detection system based on the conjugated interferometer (CI) is proposed and experimentally demonstrated. It can realize the concentration detection of mixture gas in the environment. The CI can transform the absorption spectrum of the target gases to a conjugated emission spectrum, when combining the CI with the broadband light source, the spectrum of output light matches well with the absorption spectrum of target gases. The CI design for different target gases can be achieved by replacing the kind of target absorbing gas in the CI filter. The traditional fiber gas sensor system requires multiple light sources for detection when there are several kinds of gases, and this problem has been solved by using the CI filter combined with the broadband light source. The experimental results show that the system can detect the concentration of multi-component gases, which are mixed with C2H2 and NH3. Experimental results also show a good concentration sensing linearity..
Photonic Sensors
- Publication Date: Jan. 01, 1900
- Vol. 7, Issue 3, 261 (2017)
Design and Optimization of the CFRP Mirror Components
Lei WEI, Lei ZHANG, and Xiaoxue GONG
As carbon fiber reinforced polymer (CFRP) material has been developed and demonstrated as an effective material in lightweight telescope reflector manufacturing recently, the authors of this article have extended to apply this material on the lightweight space camera mirror design and fabrication. By CFRP composite lamAs carbon fiber reinforced polymer (CFRP) material has been developed and demonstrated as an effective material in lightweight telescope reflector manufacturing recently, the authors of this article have extended to apply this material on the lightweight space camera mirror design and fabrication. By CFRP composite laminate design and optimization using finite element method (FEM) analysis, a spherical mirror with ?316 mm diameter whose core cell reinforcement is an isogrid configuration is fabricated. Compared with traditional ways of applying ultra-low-expansion glass (ULE) on the CFRP mirror surface, the method of nickel electroplating on the surface effectively reduces the processing cost and difficulty of the CFRP mirror. Through the FEM analysis, the first order resonance frequency of the CFRP mirror components reaches up to 652.3 Hz. Under gravity affection coupling with +5 ℃ temperature rising, the mirror surface shape root-mean-square values (RMS) at the optical axis horizontal state is 5.74 nm, which meets mechanical and optical requirements of the mirror components on space camera..
Photonic Sensors
- Publication Date: Jan. 01, 1900
- Vol. 7, Issue 3, 270 (2017)
Optimization of Top Coupling Grating for Very Long Wavelength QWIP Based on Surface Plasmon
Guodong WANG, Junling SHEN, Xiaolian LIU, Lu NI, and Saili WANG
The relative coupling efficiency of two-dimensional (2D) grating based on surface plasmon for very long wavelength quantum well infrared detector is analyzed by using the three-dimensional finite-difference time domain (3D-FDTD) method algorithm. The relative coupling efficiency with respect to the grating parameters, The relative coupling efficiency of two-dimensional (2D) grating based on surface plasmon for very long wavelength quantum well infrared detector is analyzed by using the three-dimensional finite-difference time domain (3D-FDTD) method algorithm. The relative coupling efficiency with respect to the grating parameters, such as grating pitch, duty ratio, and grating thickness, is analyzed. The calculated results show that the relative coupling efficiency would reach the largest value for the 14.5 μm incident infrared light when taking the grating pitch as 4.4 μm, the duty ratio as 0.325, and the grating thickness as 0.07 μm, respectively..
Photonic Sensors
- Publication Date: Jan. 01, 1900
- Vol. 7, Issue 3, 278 (2017)
Fiber Optic Gyroscope Dynamic North-Finder Algorithm Modeling and Analysis Based on Simulink
Zhengyi ZHANG, and Chuntong LIU
In view of the problems such as the lower automation level and the insufficient precision of the traditional fiber optic gyroscope (FOG) static north-finder, this paper focuses on the in-depth analysis of the FOG dynamic north-finder principle and algorithm. The simulation model of the FOG dynamic north found algorithmIn view of the problems such as the lower automation level and the insufficient precision of the traditional fiber optic gyroscope (FOG) static north-finder, this paper focuses on the in-depth analysis of the FOG dynamic north-finder principle and algorithm. The simulation model of the FOG dynamic north found algorithm with the least square method by points is established using Simulink toolbox, and then the platform rotation speed and sampling frequency, which affect FOG dynamic north found precision obviously, are simulated and calculated, and the optimization analysis is carried out as a key consideration. The simulation results show that, when the platform rotation speed is between 4.5 °/s and 8.5 °/s and the sampling frequency is at about 50 Hz in the case of using the parameters of this paper, the FOG dynamic north finding system can reach the higher precision. And the conclusions can provide the reference and validation for the engineering and practical of FOG dynamic north-finder..
Photonic Sensors
- Publication Date: Jan. 01, 1900
- Vol. 7, Issue 3, 283 (2017)
© Copyright 2018-2021 | Chinese Laser Press. All Rights Reserved 沪ICP备15018463号-20