Erratum: “On the design of magnetically insulated transmission lines for z-pinch loads” [Matter Radiat. Extremes 4, 027402 (2019)]

R. B. Spielman; D. B. Reisman

doi:10.1063/1.5110347

Journals >Matter and Radiation at Extremes >Volume 4 >Issue 4 >Page 049901 > Article

Matter and Radiation at Extremes
Vol. 4, Issue 4, 049901 (2019)

Erratum: “On the design of magnetically insulated transmission lines for z-pinch loads” [Matter Radiat. Extremes 4, 027402 (2019)]

R. B. Spielman^a) and D. B. Reisman

Author Affiliations

Laboratory for Laser Energetics, University of Rochester, Rochester, New York 14623-1299, USA

show less

DOI: 10.1063/1.5110347 Cite this Article

R. B. Spielman, D. B. Reisman. Erratum: “On the design of magnetically insulated transmission lines for z-pinch loads” [Matter Radiat. Extremes 4, 027402 (2019)][J]. Matter and Radiation at Extremes, 2019, 4(4): 049901 Copy Citation Text

EndNote(RIS)

BibTex

Plain Text

show less

Abstract

This erratum¹ is issued by the authors to note that part (b) of Fig. 1 was erroneously excluded in the published version of the manuscript. A correct version of Fig. 1 is provided here. The figure caption of Fig. 1 is repeated here, however the captions and text of the document remain unchanged.

Figure 1.(a) Schematic of the full double-disk MITL that shows the insulator stack, the vacuum flare region, the MITLs, the post-hole convolute, the inner disk MITL, and the load region. (b) Schematic showing the dimensions of the two MITLs being modeled. The 1.5-Ω impedance value is only for the radius and gap at that point. All units are cm.

References

[1] R. B. Spielman, D. B. Reisman. Matter Radiat. Extremes, 4, 027402(2019).